Looking for connection rod bearing Fiat 2.4

Post deleted

I’d suggest using the search function in the tuning section, as your question is quite specific and only a few people have the technical knowledge to answer

Cheers Jamie

Thank you Jamie.

mkmotorspot, if you can work out a successful solution we'd love you to write it up (with photos please ) so that future readers can benefit.

From memory the journal size for the BE is the same for the 2.0 and 2.4, I can confirm this next week when I'm back.

Does Kaci's post not answer your question about bearings? It contains both ID and OD values for both ends of the connecting rod for the 3 20valve variants.

Yes. If you have a standard Stilo crankshaft and standard Stilo connecting rods then you need Stilo bearings.

But also read the section of Kaci's post where it talks about the small end bearings. It seems to suggest that you can't add fiat Coupe turbo pistons to Stilo connecting rods

mkmotorsport.
I tried to put data that is useful and answers most of your questions. If the chart doesn't make it clear what is compatible and what isn't, you better get someone to read it for you. I can't believe you start tuning an engine without basic knowledge. At least I can't think of how the forum can help you more than what it has collected as a database!It is true that the internet only gives information but unfortunately not knowledge, but without it we will all be wasting our time! Greetings and good luck from me. I'm sorry and I apologize if I was more rude than necessary!

.

mkmotorsport, the sort of language you are using in this forum, although admirable that you have a fluent use of English, is not acceptable here.

You signed up to the Forum Rules which clearly point this out.

You have asked me to delete your forum membership which will be done, and your offensive post will be deleted.

Edit: mkmotorsport's posts deleted on request.